Which scenario describes a function provided by the transport layer? Configure the switch port interface with subinterfaces. Which command is used on both routers to configure the new bandwidth setting? The login command is entered in R1 config-line mode. A banner message should make it clear that only authorized personnel should attempt to access the device. What output will be displayed? For what reason is the failure occurring? How do hosts ensure that their packets are directed to the correct network destination? Not all targets are used. Flash memory is nonvolatile since it retains stored contents during a loss of power. They always direct their packets to the default gateway, which will be responsible for the packet delivery.
Perform the tasks in the activity instructions and then answer the question. Ethernet ports are limited on a router. If the technician has not saved the configuration, which two types of information will be lost? The enable secret command is used to apply a password used on the router to access the privileged mode. What output will be displayed? They search in their own local routing table for a route to the network destination address and pass this information to the default gateway. You will get passed scored 100% with this version 6.
However, when a switch is accessed remotely through the network, it must have a Layer 3 address. Not all targets are used. In some cases, this is not necessary, because for some applications a certain amount of data loss is tolerable. There is no k6 value. A new network administrator has been asked to enter a banner message on a Cisco device.
The0and 4 parameters specify ports 0 through 4, or a maximum of five simultaneous Telnet connections. How will the packet be sent? The hardware functions by using drivers and their underlying electronics. Perform the tasks in the activity instructions and then answer the question or complete the task. The server is sending the file using 100-byte segments. The Identification field is used to reorder fragmented packets.
R3 has two possible paths to the 172. Not all options are used. By default the hold time is 3 times greater than the hello interval. What is the fastest way a network administrator could test whether the banner is properly configured? A physical topology that is a variation or combination of a point-to-point, hub and spoke, or mesh topology is commonly known as a hybrid topology. The movie and sound are encoded within the transport layer header.
Each version have 1 to 10 different questions or more. Match the configuration mode with the command that is available in that mode. The enable password on all devices is cisco. In some cases, this is not necessary, because for some applications a certain amount of data loss is tolerable. The feature of its operation without regard to the data carried in each packet allows the network layer to carry packets for multiple types of communications.
The service password-encryption command is entered in global configuration mode. If the technician has not saved the configuration, which two types of information will be lost? Directly-connected and local routes have no next hop, because they do not require going through another router to be reached. Not all options are used. The packet will first be sent to the default gateway, and then from the default gateway it will be sent directly to the destination host. The broadcast address for this network would be 172. Suddenly, power to the router is lost. Perform the tasks in the activity instructions and then answer the question.
What is the correct summarization for these eight networks? The networks to be summarized are 172. The changes did not solve the problem and were not saved. Which statement is true about the implementation of summarization in this network? For the first test, to switch 2, the results are successful, with four reply messages received. The enable password on all devices is cisco. Which three statements are advantages of using automatic summarization? At what point would a router, which is in the path to the destination device, stop forwarding the packet? Which two features are characteristics of flash memory? What is causing the problem? This interface can also be used to connect routers to each other.
Not all options are used. The small company shown uses static routing. Not all options are used. Perform the tasks in the activity instructions and then answer the question. Configure the switch port interface with subinterfaces. Explain: As soon as configuration commands are entered into a router, they modify the device immediately. Routers, not switches, function as default gateways.