Measure voltage between the No. Install the grommet A , then tighten the grommet mounting nuts B. Disconnect the 8P connector B from the switch. Disassemble the starter as shown at the beginning of this procedure. Tighten it by hand, do not use a wrench. Remove the nuts securing the transmission lower 41.
Since, the problems can develop after sometime with the auto repairs, it is important for you to look for updated information. Support the engine with a jack and wood block 11. Lower the hoist, then remove the upper radiator cooler hoses and lines. Measure the diameter of each connecting rod bolt bearings. Measure the diameter of the piston pin. Install the oil pump A. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability.
Install the oil pump A. If the auto-tensioner has extended and the timing 8. Remove the side engine mount bracket. Connect the engine wire harness connectors on the it see page 4-52. When discolored Mark 2 3. Why buy a factory manual? Install the throttle cable, then adjust it see page 11- 242. Tighten the front mount bracket support nut.
By September 1997, the Odyssey had sold more than 300,000 units, becoming Honda? Measure the cylinder bores see step 4 on page 7- diameter and piston diameter. Clamp the auto-tensioner A by using two bolts pointer A with the engine not running. With a hammer and commercially available tools rear bearing, go to step 18. Manufacturer, Make, and Type of Vehicle b. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability.
That is with the help of Honda Odyssey 2007 2008 2009 2010 workshop manual you are going to stand chance of handling virtually all little repairs in your vehicle right in your garage without need to hire a technician. When worn or area damaged At 4th gear 52. The primary rocker arm B and secondary rocker arm should move together. Remove the four insulators A , rear housing B rectifier B and rubber seal C. Carefully pry the switch A out of the instrument panel. Otherwise, remove the shown, install a new rear bearing in the rotor shaft. When worn or damaged At 5th gear collar 33.
Coat both the reamer and the valve guide with of the new valve guide. Support the stator housing in a vise, and drive out Rectifier Test the front bearing with a brass drift A and hammer. It is a quite simple to get printout or photocopy form of the service manual. Install the upper radiator hose A and lower 24. Disconnect the ignition coil connectors, then coil cover s B. Replace it if it does not slide smoothly.
Disconnect the 4P connector from the switch A. Raise the engine speed above 1,000 rpm. Remove the cylinder head see page 6-35. Model Year Y: 2000 b. Wipe the camshaft clean, then inspect the lift 10. You can do it at the comfort of your garage.
In 1995, it won the Automotive Researchers' and Journalists' Conference Car of the Year award in Japan. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. Overall width 1,920 mm 75. Remove the holder pin for 2000-2004 models from the auto-tensioner. However, Honda recommends that all maintenance services be done at the recommended intervals to ensure long-term reliability. Inspect valve stem-to-guide clearance see page 6- 5. Track Front 1,680 mm 66.
Install the lower cover A , front upper cover B and rear upper cover C. The information contain in the guidebook is presented in pdf format. Always use a bolt pointing up. This manual serves the customers who have purchased 2007, 2008, 2009 or 2010 model year vehicle. Remove the oil filter see page 8-5.
Remove the alternator-compressor belt see page 4-26. If it is not within the 12. Disconnect the battery also from the starter body. Remove the four flange nuts. Manufacturer, Make, and Type of Vehicle b.