So you can follow the test and confirm what exact problem is there in your case of headlights not working:----- Click the link below: ----- All headlights not working? Item in Good Condition Guaranteed If the part we ship to you arrives in damaged or non-working condition, we will ship another item out to you immediately. This is completely normal and is no cause for concern. Simply pull it out of the headlight assembly. Insert the bulb in the rear of the headlight assembly, lining up the tabs on the bulb with the notches in the headlight assembly, and twist it clockwise to lock the bulb in place. Once installed, I was concerned about all of the moisture trapped under the material. Our manufacturers only produce replacement lights that meet the highest of industry standards, ensuring on-road safety and reducing the probability of breakdowns in component construction.
When you apply the protector film, get a hairdryer and have it ready. There is just one more trick to this. I was delighted to find that somehow the covers made the light haze on the one troublesome lens disappear. Our goal is to keep our customers happy for a lifetime and always reach a fair resolution to any issue. These bulbs have a very high voltage that runs through them, even if the battery is disconnected.
About a week later, I was blown away about how crystal clear they have become. I was able to remove almost all the air bubbles with my fingers then used the squeegee to remove the soapy solution. I highly recommend this product. Locate the back of the headlight assembly, just behind the headlight. It should come free and flip open, freeing the bulb. By doing so, you will now see the other two bottom bolts holding the headlight in. That does not mean that a product that simply and naturally wears out from normal use is a candidate for a warranty replacement or a refund.
The LampGard Headlight Protection is the very best product one can imagine. We recommend that you seek professional assistance if you are continuing to have installation issues. I am a happy customer! Once the excess is properly spread about the perimeter of the LampGard, the material will easily lay flat on the lens. Fair is defined as being fair to both you the customer and to WeatherTech. This is a wire latch that looks somewhat like a bent paper clip.
My car had four pieces running lights and headlamps and all were precision-cut to fit like a glove. We bought mew headlamps because the original ones yellowed and became hazy so badly. On larger headlamp pieces, the wet installation method is recommended as bubbles and improper alignment of the material are far less likely. Additionally, the dealer didn't have the part in stock and it would be 1-2 weeks until they got one. The film is very thick and hard to work with if you can't keep it heated. Then the entire headlight assembly including the turn signal can be slided out together.
I am very pleased with these covers. It only takes 2 of them to remove the housing. Best Price Guaranteed Our prices are hands-down some of the lowest you'll find on the net. Installation WeatherTech recommends professional installation, but LampGard comes with easy-to-follow instructions and applies to headlamps, fog lamps, turn indicators and parking lights when applicable to protect them from scratching and pitting. I ordered these headlight covers for a Mazda I prepped for shipment to Alaska. Press it down and move it to the side, away from the light bulb.
These things softened right up with a little heat, they stuck and moulded right on to fit like a glove! And two more near the back of the assembly, near the area where you would change a headlight bulb. Some Toyotas have high intensity discharge headlights, sometimes referred to as xenon lights. Thanks Aug 07, 2011 Open the trunk and along the bottom of the tail light, there should be a Philips screw securing a cover piece. You will need a helper. This is especially the case if the lamp is spherical in shape.
Very much pleased with the product. We are reasonable people and we believe in true customer satisfaction. One cleared up beautifully, but the other was still a little hazy no matter what i tried. There are two bolts on top of the headlight assembly. Question is where they are and how to get to them.