Refer to the Folding Down The Rear Seats section in this chapter for information on how to operate the rear seats. When the system activates, the brake pedal will travel with very little effort; this is normal. Insert the straight end of the jack handle into the guide tube. Dolby noise reduction reduces the amount of hiss and static during tape playback. The more you know and understand about your vehicle, the greater the safety and pleasure you will derive from driving it. The door s will lock again, the horn will chirp once and the lamps will flash. In a collision, people riding in these areas are more likely to be seriously injured or killed.
The decisions of the Board are binding on Ford and, in some cases, on the dealer but not on consumers who are free to pursue other remedies available to them under state or federal law. Refer to Compass zone adjustment in this section. The magazine does not need to be full for the changer to operate. The tone pattern will repeat periodically until the problem and warning light are repaired. Replacing the interior bulbs Check the operation of all bulbs frequently. Improper use of the power point can cause damage not covered by your warranty.
Open the liftgate, then locate the access panel on the floor behind the 3rd row seat. Please ensure that the seat is in the upright, fully latched position before putting the vehicle in motion. Contact your dealer if the window sticker is not supplied with your vehicle. The fuel system may be under pressure. Observe the application instructions on the products.
These products are available from your dealer. To avoid scratching the lamps, do not use a dry paper towel, chemical solvents or abrasive cleaners. Adjust the height of the shoulder belt so the belt rests across the middle of your shoulder. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and 2 This device must accept any interference received, including interference that may cause undesired operation. This will force most of the hot, stale air out of the vehicle. This may consist of cornstarch, talcum powder to lubricate the bag or sodium compounds e.
Attach the new wiper to the wiper arm and press it into place until a click is heard. Press and release the programmed HomeLink button. If your vehicle is particularly dirty, use a quality car wash detergent. If the light fails to illuminate, continues to flash or remains on, have the system serviced. Press the control to activate and deactivate Dolby noise reduction.
Locate the anchor webbing loop for the seating position. SecuriLock anti-theft system This light indicates the anti-theft alarm system is armed. Maximum Load Single kg lbs. Record the highway fuel economy for future reference. To properly adjust your head restraints, lift the head restraint so that it is located directly behind your head or as close to that position as possible. Fill the fuel tank completely and record the initial odometer reading in kilometers or miles.
Ford Motor Company has not approved a slingbelt towing procedure. Determine which magnetic zone you are in for your geographic location by referring to the zone map. If you do not hold the brake pedal down, your vehicle may move unexpectedly and injure someone. Identifying relays box 1 components. Grasp the bulb only by its plastic base and do not touch the glass. Identifying power distribution box fuses and releys.
Driving with the parking brake on will cause the brakes to wear out quickly and reduce fuel economy. Navigation Menu You are able to make various adjustments in navigation mode. If the dissimilar spare tire or wheel is damaged, it should be replaced rather than repaired. This provides an additional warning to other drivers that your vehicle is about to turn. In normal operation, automotive brake systems may emit occasional or intermittent squeal or groan noises when the brakes are applied. Replacing running board lamp bulbs For bulb replacement, see a dealer or qualified technician. Make sure the headlamps and vehicle accessories are off.
Dealer or salvage yard is a source. Ford Motor Company and Ford of Canada do not access event data recorder information without obtaining consent,. Make sure the tongue is securely fastened in the buckle. For more information, refer to the Seating and safety restraints chapter. You can override fan speed at any time.