Heated seat switch if so equipped P. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible. Dollars rounded to the nearest whole dollar. G Where there is a risk of eye contact, eye protection should be worn, for example, chemical goggles or face shields; in addition an eye wash facility should be provided. Doing so could impair active head restraint function. After repairs, re-check that the problem has been completely eliminated.
If the belt is not locked, repeat steps 3 through 6. Put probes at the load side of fuse terminal and a known good ground. Follow these important driving rules to help ensure a safe and comfortable trip for you and your passengers! Please read through this manual before operating your vehicle. Even though its model designation suggests the next generation Pathfinder the R52 is a different platform that shares nothing with the Pathfinders of the past. After the child restraint is removed and the seat belt fully retracted, the automatic locking mode child restraint mode is canceled. It reverts to emer- gency locking mode when the seat belt is fully retracted. The engine size grew from 3.
G First aid treatment should be obtained immediately for open cuts and wounds. Pull up on the shoulder belt to remove any slack in the belt. Supplemental front air bags in- flate with great force. Multiple Switch The continuity of multiple switch is described in two ways as shown below. Using leaded gasoline will damage the three way catalyst. Make sure that the head restraints are lowered. Failure to do so may reduce the effec- tiveness of the entire restraint system and increase the chance or severity of injury in an accident.
The meaning of are as follows: 3. G Clean as required to assure good contact. G Be careful to prevent condensation in the control unit due to rapid temperature changes and do not let water or rain get on it. After the child restraint is removed and the seat belt is fully retracted, the automatic locking mode child restraint mode is canceled. Note in the illustration that there is an excessive 4. Then smoothly pull the belt out of the retractor. G Do not use gasoline, kerosene, diesel fuel, gas oil, thinners or solvents for cleaning skin.
Front facing child re- straints are available for children who outgrow rear facing child restraints and are at least 1 year old. G Use only the fluids and lubricants specified in this manual. G Use hand tools, power tools disassembly only and recom- mended special tools where specified for safe and efficient ser- vice repairs. Using the wiring diagrams inspect the wiring for continuity. G Connector numbers in a single circle M33 indicate harness con- nectors. They have now earned a life long customer. In addi- tion, certain fluids contained in vehicles and certain products of component wear contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
It should not move more than 1 inch 25mm. The head restraint moves forward utilizing the force that the seatback receives from the occu- pant in a rear-end collision. Check that the retractor is in the automatic locking mode by trying to pull more seat belt out of the retractor. Therefore, be sure to receive all keys from vehicle owner. Doing so may reduce its effectiveness. This entry was posted in and tagged , , , , , on by.
The illustrations should be used in reference to service matters only. G Begin probing at one end of the circuit and work your way to the other end. The child restraint should not move more than 1 inch 25 mm. Tilt steering wheel control P. G After disconnecting vacuum or air hoses, attach a tag to indicate the proper connection. To return the center seat to a seating posi- tion, lift up on the pull strap on the back of the seat base while lifting on the seatback. In any powered circuit, an open can be found by methodically checking the system for the presence of voltage.
Make sure it will get cold enough to demonstrate his complaint. Release the lever to lock the seat in position. G Reinstall bolt or screw securely. Occupant classification sensor pressure sensor P. G Loose, dirty or corroded ground wires. Torque member mounting bolt 13.
Then push the seat cushion back into place. Then lift up on the seat base and tip it forward. The R50 Pathfinder differed from its predecessor by being unibody constructed versus body on frame. HomeLinkT universal transceiver if so equipped P. To assist in at- taching the child restraint to the lower an- chors in vehicles with adjustable seatbacks, recline the seatback, latch the anchor at- tachments to the anchors, and then return the seatback to its normal upright and locked position. To lower, push and hold the lock knob and push the head restraint down.