Before servicing the vehicle, refer to the precautions section. D Avoid overfilling, or the engine could be damaged. Release the parking brake and brake pedal. Remove the 8 bearing cap bolts and remove the caps, keeping them in the correct order. Using a micrometer, measure the thickness of the removed shim.
Tighten the 6 nuts to 36 ft. The angle of deviation varies according to the geographic position of the vehicle. Before servicing the vehicle, refer to the precautions section. Clean the surfaces of the oil pans. Pull up the front deck board.
It shows the zone number is set. Cruise control actuator and bracket Air cleaner, air flow meter and air duct assembly Accelerator and throttle cables 12. D Do not sit on or place heavy objects on the remote control. Seal packing application locations-right side shown 2. Drain and recycle the engine coolant.
This does not mean that the Lexus company will ever turn out a car that cannot be prone to faults. Remove the 9 bolts and cylinder head cover. Remove the adjusting shim with a small flat prying tool and a magnetic finger. Just imagine how much you can save by doing simple repairs yourself. Install or connect the following: Negative battery cable Heater air duct Left and right ventilator louvers Window washer hoses from the ventilator louvers Top cowl seal and panel Wiper and blade assembly 6.
Remove the 8 bearing cap bolts and remove the caps, keeping them in the correct order. If they do not align, remove the belt and align the mis-matched mark s. They should ride in their seats with their seat belts properly fastened. Before servicing the vehicle, refer to the precautions section. Turn the crankshaft another 3 4. No more ruining your expensive paper shop manual with grease and dirt.
Turn off the power back door system when the power back door is not in use. If the timing belt is re-used, check that the 3 original installation marks are visible on the belt as shown Page 90 19. D In situations where the road surface is covered with ice or snow, your vehicle should be fitted with snow tires or tire chains. Pull the passenger side wiper arm upward. The computer may undergo a relearning process once the negative battery cable is reconnected. Install or connect the following: Exhaust manifold to the engine, using a new gasket.
The low washer fluid warning light in the instrument cluster comes on when the fluid level in the tank becomes nearly empty. See page 568 for Make sure the headlight, stop lights, tail lights, turn signal additional information. Tighten the nuts to 36 ft. After reconnecting the battery, check that the memorized data has been retained. Other fuel related components such as the No.
After the door is unlocked, the moon roof begins to open. Check and adjust the valves. Before servicing the vehicle, refer to the precautions section. Remove the engine roll brace. If the camshafts are removed without being kept level, the camshaft may be caught in the cylinder head, causing the head to break or the camshaft to seize. Install engine rear oil seal, as follows: A.