Depress the brake pedal and check that the engine starts when the shift lever is set in the N or P position, but does not start in other positions. Tester connection Condition Specified condition 1 - 2 -10°C 14°F 7. Check that malfunction disappears when another speaker in a good condition is installed. Turn the ignition switch off. Allow the engine to idle and wait for 10 seconds.
Check the operating sound of the height control solenoid valve. Measure the resistance according to the value s in the table below. Keep the vehicle in the stationary condition on a level surface for 1 second or more. If a component group cannot be assembled because parts are being ordered, be sure to keep all parts of the group in a separate container while proceeding with disassembly, inspection, repair and reassembly of other component groups. Page 209 Page 210 Fig. Turn the radio and receiver assy on. When the following errors are detected, it takes 70 minutes until the control is resumed.
Measure the voltage according to the value s in the table below. Measure the resistance according to the value s in the table below. Measure the resistance according to the value s in the table below. Using calipers and a straight edge, measure dimension A between the transmission and the end surface of the drive plate. Check if the same trouble occurs again. When the passenger side indicator is blinking, check the passenger side connector. Measure the resistance according to the value s in the table below.
Jack up either of the front wheels. Measure the voltage according to the value s in the table below. Remove the 4 screws and multi-display. Measure the resistance according to the value s in the table below. Check that the back-up light comes on and the reverse warning buzzer sounds when the shift lever is set in the R position, but do not function in other positions.
Measure the resistance of the wire harness side connector. Measure the resistance according to the value s in the table below. If the wear indicator wire is open, Brake Wear appears on the multi-information display, which indicates that the pad must be replaced. Thoroughly mix the repair agent Dupont paste No. There will be moments in your life when you and your car will fall out. Need all 5 parts to work. When using an analog tester, connect the positive + lead to terminal 2 and negative - lead to terminal 1 of the solar sensor.
Change the set temperature to activate the cool air bypass servomotor. Drive the vehicle straight forward. Measure the resistance according to the value s in the table below. Measure the resistance according to the value s in the table below. Need all 3 parts to work. Remove the torque converter clutch.
Remove the front fender liner. Disconnect the C27 or C29 blower connector. The position sensor is built in the air inlet servomotor. Align the socket with the notch on the cigarette lighter bezel stay, push in the cigarette lighter assy as hard as possible to install it. Bookmark type, alphabetical arrangement and supportive tools have made the service manual only one of its kind.
Multi-path A radio signal can sometimes be reflected by an obstruction in its path. Solar sensor covered by a cloth. In addition, during cornering braking, it also controls the brake forces of the right and left wheels, helping to maintain vehicle behavior. Measure the resistance according to the value s in the table below. Disconnect the connector and remove the bolt. Remove the 4 bolts and separate the engine rear mounting member.