Drive in a moderate fashion avoid heavy acceleration and deceleration and have your vehicle serviced immediately by your authorized dealer. Get access to our 2011 Ford F-250 Super Duty repair information right now, online. The more you know and understand about your vehicle, the greater the safety and pleasure you will derive from driving it. Pull control on the side of the seat to release seat cushion from storage position. Ford Motor Company and Ford of Canada do not access event data recorder. As the belt retracts, you will hear a clicking sound.
Refer to Identifying components in the engine compartment in the diesel supplement. Move the rear of the control up or down to raise or lower the seat cushion. Stop the vehicle as soon as possible, switch off the engine and let cool. Ford recommends the use of a digital or dial-type tire pressure gauge rather than a stick-type tire pressure gauge. See your authorized dealer if the problem persists. Refer to the payload description and graphic in the Vehicle loading — with and without a trailer section. Note: In order to switch off the engine while the vehicle is in motion, shift to neutral and use the brakes to bring the vehicle to a safe stop.
Remove the panel cover to access the fuses. It is important to follow the proper wheel mounting and lug nut torque procedures. Pull the lever again to deactivate. Your primary responsibility is the safe operation of the vehicle. To open the tailgate step: 1. Insert the first previously programmed coded key into the ignition and turn the ignition from the 1 off position to the 3 on position maintain ignition in the 3 on position for at least one second, but no more than 10 seconds. Don't waste time calling around to your local bookstores or waiting for a repair manual to arrive by mail.
The indicator light above the selected button will turn on to confirm that the Car2U system is responding to the button command. If the Safety Canopy is not replaced, it will not function again, which will increase the risk of injury in a future collision. Install the new bulb s in reverse order. Your results will be most accurate if your filling method is consistent. To program a non Ford-approved remote start system as MyKey , do the following: 1. Twist a thin coin in the slot near the key ring to remove the battery cover 1.
For vehicles with adjustable head restraints, route the tether strap under the head restraint and between the head restraint posts, other wise route the tether strap over the top of the seatback. Repeat this procedure for each tire, including the spare. Note: The SecuriLock passive anti-theft system is not compatible with non-Ford aftermarket remote start systems. This increases traction which may enable you to safely drive over terrain and road conditions that a conventional two-wheel drive vehicle cannot. The Safety Canopy system including the A, B, C, and D pillar trim and headliner must be inspected and serviced by an authorized dealer. Use of any tire or wheel not recommended by Ford can affect the safety and performance of your vehicle, which could result in an increased risk of loss of vehicle control, vehicle rollover, personal injury and death.
Take your vehicle to a service facility as soon as possible. This timer will stop when the vehicle is turned off and will restart when the vehicle is restarted. Press to automatically move the driver seat, power mirrors and adjustable pedals to the desired memory position. Have your tow truck operator refer to this manual for proper hook-up and towing procedures for your vehicle. Please take the time to get well acquainted with your vehicle by reading this handbook.
Allow the engine to idle for at least one minute. The door will open to the full open position. You are strongly urged to buy a reliable tire pressure gauge, as automatic service station gauges may be inaccurate. Rotate the bulb socket counterclockwise and remove from lamp assembly. Make sure that the pedal is fully released. This position should only be used when towing the vehicle.
Check fuel cap: Displays when the fuel cap may not be properly installed. The diesel exhaust fluid must be replaced to resume normal operation of the vehicle. Maximum Load Single lb kg at psi kPa cold: Indicates the maximum load and tire pressure when the tire is used as a single; defined as two tires total on the rear axle. After airbag deployment, it is normal to notice a smoke-like, powdery residue or smell the burnt propellant. This indicates the safety belt is now in the automatic locking mode. Fog lamp control if equipped The headlamp control also operates the fog lamps.
Always come to a complete stop before shifting into and out of R Reverse. Press the switches on either side of the dome lamp to turn the lamps on. Refer to the Brakes section of this chapter for additional information on the operation of the anti-lock brake system. PowertrainCare — Covers 29 critical components. Adaptive transmission shift strategy offers the optimal transmission operation and shift quality.