In turn, this may cause corrosion, open circuits, or short circuits. P0137 Rear Heated Oxygen Sensor Bank 1 harness is open or shorted. Refer to Testing for Continuity and Wiring Repairs in Wiring Systems. Remove serpentine belt via the belt tensioner. Here are some of the most common. To install camshaft sprockets: Place camshaft sprocket on camshaft. Rotate pump by hand to check for freedom of movement.
I hope this help on your problem. Measuring the auto tensioner rod-3. The camshaft position sensor senses the piston position. Remove and discard O-ring seal. Take care not to scratch or gouge sealing surface Installation Install new O-ring into groove. It does not mean that it was bad to the point of a misfire, just that the properties of the spark were not what was expected. If it is coil on plug, then the camshaft position sensor is different.
Refer to Engine for procedure. Again, for intermittent faults, try wiggle-testing and checking components over - see if you can get the code to set. Mark belt running direction for installation Fig. Pull the camshaft sensor straight out with a slight twisting motion. Now, since the cam sensor can not be tested with a simple resistance test Ohms , the test I'm gonna' show you is a dynamic test done by cranking the engine by hand. Always turn counter clockwise to loosen. P0341 Camshaft position sensor harness or connectors The sensor circuit is open or shorted.
The first time the diagnostic fails, the control module stores this information in the Failure Records. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records. You didn't mention what year or engine but, if it is a 4. Refer to Engine for procedure. I put it on the car and the car started ok, I cleared the P0420 code but now I have another code P0341.
Remove right front lower fender shield. Always tighten to manufacturer's recommended torque. The First step you should do is : Locate the Camsahaft sensor, Is located On Right Front of the Engine. The engine camshaft rotation is synchronised with the crankshaft. If any fins on the back side of the harmonic balancer are bent, damaged, or missing, replace the harmonic balancer assembly.
It is supposed to be 12 volts. Leave the woodruff key in the crankshaft. It was obvious engine has been d. Did you find and correct the condition? Disconnect the negative battery cable. Secondary ignition wires arcing to wiring harness. Refer to Wiring Repairs in Wiring Systems.
How do you troubleshoot code P0341? You must remove the radiator hose and then the two bolts that hold the thermostat housing in place. The change in the magnetic field cause the voltage from the sensor to change. Right-hand camshaft pulley, with the flange side outward. This information is used by the Engine Control Module to control ignition and fuel injection. If is The connector in good condition. Do you have sparkplug wires or are the coils mounted right on top of the sparkplugs? The changing gap causes the magnetic field near the sensor to change. The mechanic is telling me now that he cant help me any longer, he did his job.
Also, I get a tiny hesitation while accelerating and then again when I settle in at any top speed like 55mph or 60mph. Rotate the front camshaft sprocket in opposite direction to take up belt slack. How does a mechanic diagnose the P0341 code? P0131 Front Heated Oxygen Sensor Bank 1 harness is open or shorted. P0137 Rear Heated Oxygen Sensor Bank 1 harness is open or shorted. The thermostat will be underneath the housing.
Jack up the front passenger side of the car and safely support it on jack-stands. An improperly located O-ring may cause damage to the O-ring and cause a coolant leak. Hold camshaft sprocket with Special tool C-4687 and adaptor C-4687-1 while removing bolt. Replace the Camshaft Position sensor. Hope this helps and please visit my auto-repair-website and give me a thumbs up.