C0550 code captiva. Holden—Captiva—Electronic Brake Control Module 2019-01-14
Why is my ABS TCS light on — Ricks Free Auto Repair Advice Ricks Free Auto Repair Advice
If problem was not found, go to step 15. If problem was not found, go to step 15. After repairs, go to step 10. Check vehicle for proper alignment. .
Service Manual2008 Captiva Diagnostic Trouble Code (DTC) P0500
C0550 code for the pushrod design which uses solenoids to alter the oil pressure delivered to the lifters. Refer to Repair Procedures Cell 5 in Electrical Diagnosis. After repairs, go to step 19. If resistance is not 0-5 ohms, go to step 10. If voltage is not 0. I hope this helps someone in the future as I found very little information using the C0550 code in my searches.
C0551 Engine Code Meaning
After repairs, go to step 19. After repairs, go to next step. After repairs, go to step 15. If problem was not found, go to step 15. Spray the suspected area with a five percent saltwater solution. However, also includes disassembly instructions for interior trim panels and exterior items like headlights and tail lights.
C0550? Help
If problem was not found, go to step 13. If voltage is less than 5. An intermittent may be caused by a poor connection, rubbed-through wire insulation, or a broken wire inside insulation. After repairs, go to next step. After repairs, go to step 16.
C0561 traction control code — Ricks Free Auto Repair Advice Ricks Free Auto Repair Advice
After repairs, go to step 15. Diagnostic Aids A thorough inspection of wiring and connectors is important to prevent misdiagnosis. If problem was not found, go to next step. If problem was not found, go to step 18. If problem was found, repair as necessary.
C0550 and no 4wd problems
Depress and hold accelerator pedal between 15 degrees and 45 degrees for at least 4 seconds. After repairs, go to step 14. After repairs, go to step 19. If problem was not found, go to step 15. Turn ignition on, engine off.
Strange ABS error C0550 misleading
An intermittent may be caused by a poor connection, rubbed-through wire insulation, or a broken wire inside insulation. After repairs, go to step 14. If problem is found, repair as necessary. After repairs, go to step 12. After repairs, go to next step. After repairs, go to next step. If voltage is equal to battery voltage, go to next step.
P0014 CHEVROLET Exhaust Camshaft Position System Performance
If problem was not found, go to step 11. If voltage is greater than 7. If any problems are found, go to next step. Usable output voltage range for lateral accelerometer 0. If voltage is not 0-17. Desired yaw rate is calculated from measured steering wheel position, vehicle speed, and lateral acceleration. Turn ignition on, engine off.