If voltage is not more than one volt, go to step 16. If duty cycle is not 5-95 percent, go to step 6. The problem front left brake caliper locking up. If problem was found, repair as necessary. If voltage is not greater than 10 volts, go to step 6. If frequency is not 121-134, go to next step. If problem was found, repair as necessary.
Lateral Accelerometer Circuit Malfunction C0187 3 ………. If problem was found, repair as necessary. After repairs, go to step 14. If resistance is 0-5 ohms, go to step 10. If problem was found, repair as necessary.
Yukon Denali models have an even more potent 6. If problem was not found, go to step 12. Turn ignition on, engine off. If resistance is not infinite, go to next step. The infotainment system is easy to use, with intuitive menus and a straightforward control layout.
If voltage is not less than 5. If problem was found, repair as necessary. After repairs, go to step 12. After repairs, go to step 12. Turn ignition switch on, engine off. Turn ignition on, engine off.
If resistance is 0-5 ohms, go to next step. If a short to voltage is found in the jumper harness, replace the jumper harness. After repairs, go to step 15. The Expedition gets lower fuel economy estimates, and its cabin is fitted with low-rent plastics on most surfaces. Thanks for all advise and assistance on this problem and I hope this prevents others from spending as much as I have. If lateral accelerometer signal is greater than 0. Usable output voltage range for lateral accelerometer is 0.
Check delivered torque signal circuit for short to voltage. Refer to Repair Procedures Cell 5 in Electrical Diagnosis. After repairs, go to step 15. After repairs, go to next step. If problem was found, repair as necessary.
If centering procedure was not successfully completed, go to step 5. If problem was found, repair as necessary. Condition must exist for more than 500 milliseconds with vehicle speed above 3. Diagnostic Aids Perform steering angle sensor centering procedure. Scan tool will report zero lateral acceleration as 2. An intermittent may be caused by a poor connection, rubbed-through wire insulation, or a broken wire inside insulation.
Diagnostic Aids A thorough inspection of wiring and connectors is important to prevent misdiagnosis. Check for backed-out terminals, improper mating, broken locks, improperly formed or damaged terminals, poor terminal-to-wiring connections, or damaged wiring harness. If problem was found, repair as necessary. The Denali trim has a more potent V8 engine, adaptive suspension, and heated second-row captain's chairs. Turn ignition on, engine off. If resistance is not 0-5 ohms, go to next step.
Turn ignition on, engine off. If problem is found, repair as necessary. Check vehicle for proper alignment. Left Front Wheel Speed Circuit Malfunction C0036 …………. If problem was not found, go to step 14. Inspect other low voltage conditions. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely.
After repairs, go to step 15. If problem was not found, go to step 12. If voltage is more than one volt, go to next step. Depress and hold accelerator pedal between 15 degrees and 45 degrees for at least 4 seconds. If problem was found, repair as necessary. Additional benefits like towing and roadside assistance may be available, so read carefully. After repairs, go to step 19.