His started Aug 20,2018, wen I start the car, the engine makes noise shakes during a cold start. So, I ruled out exhaust leak as the cause of the noise even though there is an exhaust leak that I need to fix. I have been driving a car with a substantial defect from the day one. I decided to rig up an attachment that screws into my spark plug openings for my air compressor so that I could do a crude leak-down test. I went to a dealer who said I had run out of oil but he didn't know why. Will wait another week and see. Not a major or expensive repair.
Sep 14, 2012 Many times, rear tires that are out of round or severely cupped or feathered, or that are out of balance can create this type of issue. Unlike the cheaper Haynes and Chilton manuals that cover multiple year models, leaving the exact information you need to fix your car, these professional manuals cover your exact year, make, model. There are a lot of things that can cause them. I have a real issue with using oil other than what is recommended for the vehicle. Took car to nearby goodyear service facility to check system. I went to another mechanic- again no reason.
Honda motorwerks of la crosse service rep said wait until notified. Tie rods can be felt in the steering wheel at a stop. If the crank is too bad, I may not bother, but the question then is - what is too bad? I will never be able to drive this vehicle without being fearful. Thumping increases in proportion to engine power input; worse when accelerating or steady hill climb. I took the car to the dealer and he said my fuel injectors were bad and charged me approx.
Apparently Honda uses substandard metals in the compressors since this is a recurring problem. The cause is excess clearance between the rocker bridge and the rocker shaft. I hear the clicking best from near the front driver side of the engine now seems center of engine, see edit 2 although it is hard to pinpoint. I am hesitant to go deeper into the engine. I found that it was a manufacturing defect in 2013 model. Before I knew this, more than one garage has installed the wrong one… I have also had this problem - I believe that it is the anti sway bar bushings squeakingIt is indeed the anti-sway bar bushings. There was no clicking associated with normal starting.
I have already replaced the valves on mine once at about 87,327 miles. Plus, they contain full trouble code descriptions and troubleshooting instructions. There is a noise upon cold starting. Honda seems they are not considering me a good customer but how can I forget that I spent 25k+ on the car which is just a headache to drive, not safe and get it fixed. Shortly after that the air conditioner stopped working, and was running funny. I couldn't tell if it was damaged or just partially discolored.
It is not safe to drive. The car is no longer safe or dependable due to cc and brakes. I had no choice but to pull over to the side of the road and wait for a tow truck to take me to the dealership. The adjuster could not be turned out any further. The 4 cylinder has low compression due to a burned exhaust valve. Make sure you have the right weight oil, and the rite amount.
This is what i did to my 1999 honda cr-v except the valve adjustment, Im not good enough to mess with that on my own. Doing it myself turned out pretty cheap, and easy, just time consuming. Compressor had blown apart-several sizable chunks were recovered. It only has 1700 miles, but so far it has stalled on me 3 times while driving. All you need is a good torque wrench and sockets.
Please help us Cr-v owners. Also the fact that one of the valves can't be adjusted means having to do a valve job and removing the head. Worried that this may make the situation worse since they will not be wear-mated surfaces. Front shock absorbers replaced last year. I listened to the noise this morning. Noticed fuel in oil, found cams were binding and timing chain was stretched and loose.
The pads can only fit in one way as there are notches and grooves that must be aligned properly to slide them in. The thumping only occurs when engine supplying power. You can't just purchase a standard sized Honda bearing. They also have not declared a recall. I do not feel safe driving this car and I am concerned that it will fail, resulting in an accident.