To properly adjust your head restraints, lift the head restraint so that it is located directly behind your head or as close to that position as possible. Press and hold the button to reset. Take precautions to avoid its dangerous effects. If sprayed on the windshield, engine coolant could make it difficult to see through the windshield. Fold vinyl edges towards center, making sure that the edges clear the end cap slots. Displayed when the tire pressure monitoring system is turned off.
Stop the vehicle as soon as safely possible, turn off the engine and let it cool. Each time you fill the tank, record the amount of fuel added in liters or gallons. Insert the belt tongue into the proper buckle for that seating position until you hear and feel the latch engage. P - Park Always come to a complete stop before shifting into or out of P Park. If necessary, add fluid in.
Pull bulb from bulb holder. If the wiper does not wipe properly, substances on the windshield, rear window or the wiper blades may be the cause. The alarm system will still be armed. Insert the belt tongue into the proper buckle the buckle closest to the direction the tongue is coming from for that seating position until. If the warning stays on or continues to come on, have the system checked by your dealer. Each tire is equipped with a tire pressure sensor mounted on the wheel inside the tire behind the valve stem.
Do not tow with slingbelt equipment. Lift release handle upward to unlatch seat. See your Ford or Lincoln Mercury dealer. It should not be necessary to add any aftermarket products to your fuel tank if you continue to use a high-quality fuel. Extra precautions, such as slower speeds and increased stopping distance, should be taken when driving a heavily loaded vehicle. Tighten the thumbwheel at both ends of the cross-bar. If the engine reaches a preset over-temperature condition, the engine will automatically switch to alternating cylinder operation.
Contact your Ford dealer for a free tether anchor kit 613D74 so you can attach a tether anchor bracket to the tether anchor attachment locations in the rear floor. The reservoir must be filled slowly to allow trapped air to escape. Push or pull head restraint to desired position. Follow these guidelines to ensure proper emission system operation: Use only unleaded fuel. The system is deactivated by releasing the brake pedal. The automatic locking mode is not available on the driver safety belt.
Indicates the transmission is overheating. Press rocker switch to close window. A correct zone setting will eliminate this error. Check to make sure the coded key is an approved Mercury coded key. Allow the safety belt to retract to remove any slack in the belt. To enter the 3rd row seat: 1.
If you hear the chains rub or bang against your vehicle, stop and re-tighten the chains. The driver side power window has a one touch down feature. Normal braking operation is still effective unless the light is also illuminated. . If your vehicle seems to lose engine power while driving in deep sand or very deep snow, switching off the AdvanceTrac stability enhancement feature will restore full engine power and will enhance momentum through the obstacle.
Treadwear The treadwear grade is a comparative rating based on the wear rate of the tire when tested under controlled conditions on a specified government test course. Clip the tether strap to the anchor. Improper use of the power outlet can cause damage not covered by your warranty. After at least three to five fuel tank fill-ups, fill the fuel tank and record the final odometer reading. The transmission and tires may be damaged or the engine can overheat. The fuel system may be under pressure. Floor console climate controls if equipped Depending on the equipment package, your vehicle may be equipped with floor console climate control capabilities.
Measure the height from the center of your headlamp to the ground and mark a 2. Press rocker switch to close the rear passenger window s. Mercury Mountaineer 1997 1998 1999 2000 2001 factory repair manual Mercury Mountaineer-First Generation 1997 1998 1999 2000 2001 Factory Manual! Set the parking brake and make sure that the gearshift is securely latched in P Park. The wheels are prevented from locking even when the brakes are firmly applied. If the fluid is low, add fluid in small amounts, continuously checking the level until it reaches the correct operating range. Rear seat passengers Press rocker switch to open right rear window.