A transmitter is in the vehicle. Sales began with model year 2013 in late 2012. Not available with lease, special finance and some other offers. See Use engine oil approved to the may be hot;. Cargo and load capacity limited by weight and distribution. See Forward Seat will pulse five times.
Keep the spare tire Jump Starting - North and its wheel together. Climate Control Systems Warning in the Index. See Power Door Locks 0 34. See Vehicle Load The maximum air pressure to white lettering, or bears Limits 0 180. Our dealership aztec chevrolet buick gmc serves beeville and corpus christi customers with a wide selection of new and used vehicles and also offers parts and service. The Federal Highway Traffic Safety Supervision presents the Encore 5 various stars for collision safety.
See Rating for the front axle. Press the power window switch until the window is fully open and briefly hold. Pull the shoulder belt all the 6. Press and hold g 2 to close the sunroof vent. If this happens, see your has been turned off by pressing and dealer for service. If it is determined that the condition is Warning Fuel can spray out if the caused by the type of fuel used, refueling nozzle is inserted repairs may not be covered by the Fuel vapors and fuel fires burn too quickly.
Cargo and load capacity limited by weight and distribution. Provides recommended oil for your vehicle, gas tank capacity, clock and radio setting, information about vital fluids, tires, routine maintenance and specific options your vehicle is equipped with. Schedule Normal are for vehicles that: Refer to the information in the Carry passengers and cargo Maintenance Schedule Additional Owner Checks and Services within recommended limits on Required Services - Severe chart. Move the shift lever from D Drive rearward to M Manual Mode. Release the switch to stop the movement.
The sunshade opens automatically with the sunroof, but must be manually closed. Place the two recognized transmitters in the center console front cupholder. See Temperature Warning Engine Overheating 0 250. To access module Transmission control the fuses, remove the cover. Assistance Systems for Parking or system current software information. Have the protected from short circuits by a headlamp wiring checked right away combination of fuses and circuit The vehicle has fuses and circuit if the lamps go on and off or breakers. Then sit well back in the seat and wear the safety belt properly.
That could cause injury to the person sitting there. Manual Rearview Mirror If equipped with a manual rearview mirror, push the tab forward for daytime use and pull it for nighttime use to avoid glare from the headlamps from behind. Light The engine coolant temperature warning light comes on when the engine has overheated. Use a de-icing agent only when absolutely necessary, and have the locks greased after using. Then lubricant, belts, cooling system, and Warning Continued apply the parking brake and brake system. H : When the button is returned to the middle position, the lamps turn on automatically when a door is opened. The engine into a drive gear while the engine the transmission could be speed may be higher and there may is running at high speed.
The lap belt could go up over your abdomen. To turn this feature on or off, see Vehicle Personalization 0 130. When the engine The outside temperature is not Warning Continued starts, let go of the button and in the required operating range, the accelerator. Always lock the vehicle whenever leaving it. Capacities Application Metric English Air Conditioning Refrigerant For the air conditioning system refrigerant type and charge amount, see the refrigerant label under the hood. It may also show Information Menu.
How to Detect a Tamper Condition If K is pressed and the horn chirps and the lights flash three times, an attempted break-in has occurred while the system was armed. If the breaking-in guideline every pushbutton start is not working, the time you get new brake New Vehicle Break-In vehicle may be near a strong radio linings. When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. Never pull the key out without pressing the button. Install the wiper blade connector To remove the cover: by sliding into the end of the wiper arm until the button on the To replace the front wiper blades: wiper blade clicks into place with the wiper arm.