Active Head Restraints, see an authorized dealer. Wheel — If Equipped The spare tire of your vehicle is equivalent in look and Because of the reduced ground clearance, do not take function as the original equipment tire and wheel found your vehicle through an automatic car wash with a on the front or rear axle of your vehicle. The angle of the seatback can be adjusted forward or Push the seat switch forward or rearward, the seat will backward. Rotate the center portion of the lever up to increase the brightness of the instrument panel lights when the park- ing lights or headlights are on. Improvements to its products without imposing any, obligation upon itself to install them products previously manufactured, special design considerations incorporated into, vehicle's electronic system to provide immunity radio.
Reinstall the glove box door dampener and glove box. Select the button 1—6 you wish to lock onto this Buttons 1 - 6 station and press and release that button. Press this button to change the display to time of day. Operation of the wipers on dry glass for long periods When performing other underhood services, the hood may cause deterioration of the wiper blades. Remove the obstruc- Press the switch forward and release it within one-half tion if this occurs. Use tires of the cause collisions. Do not use a portable battery booster pack or any other booster source with a system voltage greater than 12 Volts or damage to the battery, starter motor, alternator or electrical system may occur.
Rear Window Defroster Failure to follow these cautions can cause damage to The rear window defroster button is located on the the heating elements: climate control Mode knob. Be sure to check the fluid the vehicle body is a properly maintained engine exhaust level in the reservoir at regular intervals. These tether strap anchorages are under a provide the most direct path between the anchor and the plastic cover with this symbol on it. This means the operator can override automatic blower operation turn the the blower, the mode, or both. You can turn the feature on or To avoid damage to the mirror during cleaning, never off by pressing the button at the base of the mirror. The lenses in front of the instruments in this vehicle are molded in clear plastic. The lap portion could ride too high on your body, possibly causing internal injuries.
The garage If the indicator light stays on constantly, programming door may open and close while you train. Once you repair or replace the original road tire, and 1. Tire and Loading Information Placard Tire Placard Location. . To tilt the steering column, move the steering upward or downward. Then, the heat output will drop to the against heat, such as a blanket or cushion. Only vehicles with the E-85 fuel filler door label can operate on E-85.
Remind all children in the vehicle that the seat belts are not toys and should not be played with, and never leave your child unattended in the vehicle. Thank you so much, every penny helps. If you do not read this entire manual, you may miss important information. Press the right switch to seek up and the left switch to seek down. Insert the tip of the ignition key or similar flat-bladed object into the lock and rotate approxi- Avoid trapping anyone in a vehicle in a collision. This light indicates that the headlights are on high beam. Breathing it can make you unconscious effectiveness of the catalyst as an emissions con- and can eventually poison you.
Always be sure that your vehicle is serviced with correct ethanol com- The gas cap is behind the fuel filler door, on the left rear patible parts. Turn the steering wheel to allow access and remove the inner fender shield. Leaded gasoline will destroy the odorless. Lifting a latch at the front of the hinged the armrest down. To tilt the head restraint closer to button, located at the base of the head restraint, and push the back of your head, pull forward on the bottom of the downward on the head restraint. If the ambient temperature is 68°F 20°C and the measured tire pressure is 27 psi 186 kPa , equipment tires and wheels.
Check the wheel nuts for tightness. Flash Lights With Lock The feature will cause the turn signal lights to flash when 3. All vehicle keys must be taken to an autho- 60 seconds. Always use latch, release mechanism and safety catch should be washer fluid when using the wipers to remove salt or dirt cleaned and lubricated. The seat belt latch plate is above the back of the front seat, next to your arm. Turn to the second detent for The multifunction lever controls the operation of the headlight operation.
Loosen, but do not remove, the wheel nuts by turning with two attachment points. Position the latch plate as close as possible to the anchor point. When cleaning the lenses, care Do not use volatile solvents for cleaning purposes. Any modifications or alterations to this vehicle could seriously affect its roadworthiness and safety and may lead to a collision resulting in serious injury or death. Infants in rear facing child restraints should never 3.
This might indicate a damaged cap. Selecting high beam headlights lever. Forces gener- following procedure to temporarily move the shift lever: ated by excessive wheel speeds may cause damage, or even failure, of the axle and tires. Cold fluid is at a transmission fluid level properly: temperature below 80°F 27°. A single chime will indicate the completion of the programming.