This is a halogen bulb. Leaving unattended children in a vehicle is dangerous for a number of reasons. Our Dodge Ram 1500 2009-2010 repair manual provides you with all the mechanical guidance you need to care for and maintain your vehicle, and features step-by-step instructions, supported by over 600 photo illustrations. Attach the hook to a suitable anchor point. Before raising the wheel off the ground, make sure that the jack will not damage surrounding truck parts and adjust the jack position as required. A near-deployment event occurs when the airbag sensor detects severe vehicle deceleration usually indica- tive of a crash, but not severe enough to warrant airbag deployment. This will prevent moisture and dirt from entering the valve stem, which could damage the valve stem.
Anyone seated on the armrest could be seriously injured during vehicle operation, or an accident. The headlights will turn on when the switch is rotated to the second position. The hand-held transmitter of the device may also be used at any time. Automatic Compass Calibration This compass is self-calibrating which eliminates the need to manually set the compass. Connects a vehicle and fifth-wheel trailer with a coupling king pin. This feature plays the selections on the compact disc in random order to provide an interesting change of pace. These numbers can be used to order duplicate keys from your authorized dealer.
If dirty, clean by gently spraying water from a garden hose vertically down the face of the condenser. Parts and equipment that is, Chrysler parts equipment installed by, chrysler or by the selling retailer before the vehicle was delivered, first owner , if the repairs were necessary because of defect material, or remanufactured Chrysler parts see page 18. Drive carefully under such conditions to prevent an accident and possible per- sonal injury or property damage. Attaching a snowplow to this vehicle could adversely affect performance of the airbag system in an acci- dent. To prevent losing the end, hold the hook strap while you work.
The wire rope should be neatly wound around the spooling drum. Upon initial start-up in cold weather, the power steering pump may make noise for a short amount of time. Local commands are available if the supported radio mode is active. Turn the end of the handle to select the desired wiper speed. Acrobat Reader, Foxit, or comparable reader, to be able to open. Anyone seated on the armrest could be seriously injured during vehicle operation, or an accident. To avoid risk of forcing the vehicle off the jack, do not fully tighten the nuts until the vehicle has been lowered.
Insert the latch plate into the buckle with the release button facing out. Tons of pictures and diagrams at your fingertips!! Using the wheel wrench, finish tightening the nuts using a crisscross pattern. Never drive through standing water that is deeper than the bottom of the tire rims mounted on the vehicle. With the odometer value displayed, hold the trip button down for a period of six seconds. The pump motor makes a low humming noise during operation. When you release the anchorage, try to move it up or down to make sure that it is locked in position. Place lumber across the box in the indentations provided above the wheel housings and in the bulkhead dividers to form the floor.
Motor: The winch motor is powered by the vehicle charging system and features a thermal protection switch that automatically stops motor function in the power-in direction if the motor gets too hot. Lift the handle, located on the outboard side of the seat. Other designs may result in unsatisfactory coolant performance, poor gas mileage, and increased emissions. Place the key into the ignition. Load Floor In Open Position 3. You should never stop or shut a vehicle off when crossing deep water unless you ingested water into the engine air intake. The radio will play seven seconds of the selected channel before moving to the next channel of the selected program type.
Do not use solvents such as benzene, thinner, cleaners, or anti-static sprays. These practi- cal manuals make it easy for students and technicians to find and fix problems on computer-controlled ve- hicle systems and features. High-tech diagnostic equipment is sometimes needed service vehicle, service our cars and trucks, and we provide special technical training so, their technicians can render the skilled care your vehicle needs, warranty service must be done by an authorized Chrysler Retailer. Disengage the clutch to allow free spooling of the winch drum, rotate the clutch lever on the winch to disengage. Pull the lever toward the steering wheel to unlock the steering column. Only use the center seating position when the armrest is fully upright. Gooseneck Hitch The gooseneck hitch employs a pivoted coupling arm which attaches to a ball mounted in the bed of a pickup truck.
These protective covers for the airbag cushions are designed to open only when the airbags are inflat- ing. Hills can cause serious problems. Use of an air wrench or other power tools is not recommended and can damage the winch. Reverse the procedure for installation of the bulbs and housing. Separate the connector holding the housing and wir- ing harness to the body.
Remove the obstruc- tion if this occurs. All doors may be opened with the inside door handle without lifting the lock plunger. Be sure to consider this when determining the depth and the ability to safely cross. You can be seriously, even fatally, injured riding in a seat with the seatback reclined. These can only be edited on the cellular phone.
People belted together can crash into one another in an accident, hurting one another badly. Be careful of the moving belts and fan. This spare tire does not have a tire pressure monitor- ing sensor. Remove the dipstick, wipe it clean and reinsert it until seated. The tube extension, may be used, but is not required. Universal commands are available at all times. It can zoom in anywhere on your computer, so you can see it clearly.