It's easier to unscrew the fitting and use a Torch and melt the plastic in the fitting! The low profile socket works in confined spaces. Remove oil transmission cooler line from oil cooler outlet fitting on radiator. This is located in a very tight location. All you have to do is disconnect these two lines at the radiator, plug the holes and connect the new cooler to the lines. The quick connect fitting on the slave cylinder is recessed in the bell housing on these vehicles.
Double Overwound torsion spring designed for longer life. Start engine and inspect for leaks. After inserting into the quick connect fitting, a quarter turn of the tool quickly and easily releases the fitting on the transmission end of the transmission-to-radiator oil cooler line. Position jackstand aside and carefully remove radiator and fan shroud. Currently, the following states regulate the offer and sale of franchises: California, Hawaii, Illinois, Indiana, Maryland, Michigan, Minnesota, New York, North Dakota, Oregon, Rhode Island, South Dakota, Virginia, Washington, and Wisconsin.
Remove lower radiator hose from radiator. Connect the radiator outlet hose to the radiator. I really wasn't expecting that. Drain engine cooling system as described. Features: For R and R of Fuel Filter, Transmission and Oil cooler linesQuick Line RemovalAnodized Aluminum ConstructionKit includes all pieces from the 8100 and 8107 line disconnect sets. Non-stock item, manufacturer drop ship; please email service toolsource. Your best bet is to install a new radiator.
Was this review helpful to you? Remove upper radiator hose from water bypass tube. The fittings require a special tool to release line from fitting. Probably A379 Next, on those vans the lines and fittings are notorious for leaking and I have found best supplier for replacement lines and fittings is Dorman, really good quality aftermarket parts. Tighten the transmission oil cooler line fittings to 27 Nm 20 ft. June 19, 2014 Reviewer: Rusty from Arkansas Used to change out the rad in my 6. Do not use power tools. Remove the radiator, radiator cooling fan, air conditioning cooling fan and transmission cooler lines from the vehicle as an assembly.
Position transmission oil cooler tube and install transmission oil cooler tube bracket. Safety latch allows one-handed opening and closing. February 9, 2015 Reviewer: Glenn from Discovery Bay, Ca Works perfectly. See your Authorized Matco Tools distributor for warranty or return information on purchases made offline. Separates the fuel lines without damaging the connectors. The cooler line can then be removed.
Remove oil transmission cooler line from oil cooler outlet fitting on radiator. Remove splash shield from lower radiator support and front sub-frame. Remove transmission oil cooler line from oil cooler inlet fitting. Remove radiator overflow hose from radiator and fan shroud. Install radiator mounting bracket assembly. Remove the radiator mounting bracket assembly.
Go to where the lines and connectors are listed and look yours up. Cost about the same for a good external cooler as a new radiator. It does work, just takes a lot of patience since its plastic and doesn't hold its shape when trying to push the quick disconnect open. Remove clip retaining contant control relay module and position module aside. For vehicles equipped with automatic transaxles, disconnect transmission cooler lines at transaxle.
Raise vehicle front end as high as possible. Broke on the second line. Remove lower radiator hose from radiator. Was this review helpful to you? Remove air conditioner condenser fixing bolts and radiator bracket fixing nuts. May 07, 2010 Disconnect battery ground cable. Remove two retaining bolts for fan shroud at top of radiator and remove fan shroud from radiator. Fill and bleed cooling system.
Install lower transmission oil cooler tube. Worked as intended, saved me alot of headache. Tighten the engine oil cooler lines to 18 Nm 13 ft. Look here its a good listing of disconnect tools with the tools application along side of it. Remove transmission oil cooler bracket and position transmission oil cooler aside. Disconnect cooling fan connectorsRemove upper and lower radiator hoses after marking them to ease installation. Remove transmission oil cooler line from oil cooler inlet fitting.