Remove the ground cable A , transmission upper mount bracket plate B , and transmission upper mount bracket C. Pull the retaining spring C away from the bulb then remove the bulb. Install the rear mount stop. Click here to see how. They stopped working at 106K miles. You have to get the serial number off the radio by removing it or partially taking it out to see the numbers on it try not to remove any cords.
Install the rear mount bracket A. Remove the steering gearbox mounting bracket bolts. This update will not work in a voice-activated navigation system. Remove bottom bolts and screws. The Acura Navigation Center cannot answer detailed technical or coverage questions. Bought kit to install radio and new climate controls. The dealer put the spare on for me but did not bother to properly inflate it.
Also the heater control and radio lights had a mind of their own randomly going off and on. It's connected with some clips, so do it firmly but gently; you don't want to break off the clips. Do not disassemble the inverter unit and the igniter unit. Can my navigation system provide routing information for addresses or places in unverified areas? Make sure the cables are clean and tight on the battery and the grounds and also the starter relay on the starter as well. The current and failure mileages were approximately 96,000. A powerful computer in your vehicle then analyzes this data to pinpoint precisely the vehicle's location. Clean the areas where the intermediate shaft contacts the transmission differential with solvent or carburetor cleaner, and dry with compressed air.
The drive seemed to be working fine, but the disc had faint swirling scratches on it. After reconnecting the battery, enter the anti-theft codes for the audio system and the navigation system if equipped , then enter the audio presets. Don't pull the cup holder out all the way until you finish Step 3. Orders placed by 11:30 a. While driving approximately 10 mph in a parking lot, the contact heard a loud noise coming from the instrument panel. What can I do to improve the system's performance? How do I obtain technical advice about my navigation system? Disconnect the battery negative cable, then disconnect the positive cable.
Several years ago, I had a problem with the hands free link draining the battery. Make your way around to the other side, and once all clips are off, pull the bumper out to remove it. Tighten the mid-mount mounting bolts. What can I do to improve the system's performance? The vehicle was scheduled for another repair. He also stated that the radio had failed and would need to be replaced for the second time and the air conditioner also needed replacing for the third time. What is meant by verified and unverified roads? The vehicle was taken to an authorized dealer and the dealer advised the contact that the transmission would need replacing.
Use for comparison purposes only. Return the package, with proof of purchase, in original container to the address provided by the Acura Navigation Center. Remove the power steering fluid line bracket A from the front subframe. Your previous disc can be reinstalled, but your dealer must perform the procedure. Remove the transmission range switch connector A from its bracket B , then disconnect it.
Your navigational system was designed to provide navigational assistance only. Jul 27, 2010 You have to do this: If you have jumped or replaced the battery at anytime this will happen. Slide the steering gearbox A in the gearbox mounting bracket B on the subframe. I would really appreciate your help in this matter to avoid other persons getting this horrible experience. How do I hide or display map icons? Support the front subframe A with the special tool and a jack, and lift it up to body. For help with technical of coverage issues, consult Acura Client Relations at 1-800-382-2238. After that, there were just four screws securing the drive to the mounting bracket.
However, breaking it down into small steps makes it much easier to do. Remove trim piece, then remove four screws inside. Why isn't my address included in the navigation system database? Step 5 — Remove two trim pieces Remove the two trim pieces on each side of the center console. Found out the headlight was not a simple fix. Not having found a definitive answer, maybe you can help. Use your flat head screwdriver and pry them off very gently if you plan on re-using them. Heard a squeaky sound around the stearing wheel minutes earlier.