. Tighten the B+ nut to 13 ft. Support the transmission with a transmission jack. Remove the retainer that secures the cable to the bracket. If your vehicle has this feature, you can lock and unlock At times you may notice a decrease in range. Always wear safety goggles when working with, or around, the air bag system.
Remove the tire and wheel assembly. Front pivot bolt 15 Series Rear pivot bolt Lower control arm pivot nuts. Replacement fasteners must be the correct part number for that application. Allow system capacitor to discharge for two minutes before beginning any component service. Check constant velocity joints and axle seals Check readfront axle fluid level and add fluid as for leaking.
Pull the transmission straight back. Tighten the battery terminal nut to 71 inch lbs. Transmission Operation, Automatic 2-25 Symbols. If necessary, add only enough fluid to bring the level up to the mark. All recommended maintenance procedures are important. Install or connect the following: Alternator mounting bolts.
After operation in mud or sand, have the brake linings cleaned and checked. See Engine on page 5- 17. Place the hose on the alternator support. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use a tool to remove the two screws from the lamp assembly. Do not use any oil which does not carry this starburst symbol. Turn the wheel wrench counterclockwise to loosen the wheel nuts.
After any airbag component testing or service, do not connect the battery negative cable. Flush affected area with cool water if irritation is experienced. Road test the vehicle and test for proper operation. Technical Files and Write Ups Description: Text document of the Press Release for the '01 Sierra C3 Acobrat file on C3 features and specs C3 paces a Snow Rally! Use only original equipment fasteners listed in the parts catalog when fastener replacement is required. The other wire harness strap will surround all leads to the steering column. The wheels on the vehicle are straight ahead. Remove the old bulb from the bulb socket.
Install Tool J21366 onto the transmission bell housing to retain the torque converter. Install tool J21366 onto the transmission bell housing to retain the torque converter. Pull the rest of the shoulder belt all the way out of the retractor to set the lock. Remove or disconnect the following: Engine protection shield Frame cross bar 2500 series only Tire and wheel assembly Shock absorber Front stabilizer shaft link 3. Write down the voltage reading and proceed to the next test. Install tool J21366 onto the transmission bell housing to retain the torque converter.
This does not mean something wrong with your brakes. Failure to do so may result in occupant personal injury or death. Tighten the alternator mounting bolts to 37 ft. So much water can build up under your tires that they can actually ride on the water. The torque converter must be flush onto the flywheel and rotate freely by hand.
Remove it again, It's a good idea to check your engine oil every time you keeping the tip down, and check the level. This can help you steer around the obstacle while braking hard. Install outer tie rod nut to the outer tie rod stud. This may result in improper deployment, personal injury, or death. Tighten the oil pan bolts and fill the transmission with transmission fluid. Remove the transmission mount nuts.
If a child restraint anchor is found damaged in any way, the anchor must be replaced. Keep your hands away from moving terminal if the parts once the engine is running. Unfasten the cable nut from the stud, then remove the alternator cable. This will disable the airbag system. Transmission vent hose Fuel lines Wiring harness Heat shield. Hold the Clock spring with the face up.
Rotate the coil hub slowly, counterclockwise until the centering window appears yellow and both arrows 2 line up. With the seat folded, unlatch the seat from the floor 5. Use only original equipment fasteners listed in the parts catalog when fastener replacement is required. Lamps On Reminder 3-14 Traction Off. In a This part of the manual tells you how to use safety belts properly. Watch out for the engine cooling fan. Tighten the wing nut until free-play is eliminated.