Hi I have Liberty but my brother-in-law has a 1999 cherokee 4. Prevente4d the annoying key in ignition alarm and the lights turned themselves off after a few mintes. If you can, pick one up at a wrecking yard. The manufacturer was made aware of the issue. Thanks for all the help and the tech tips I got from all you guys. My light airbag light went out after I sprayed electrical connection spray in the wire plugs under the seat passenger seat. The wiring harness that I need for the radio controls is actually in the steering wheel underneath the airbag.
The attached pics are showing the problem areas Im working with. Airbag light and chime randomly turns on when driving, it stays few seconds, and then turns off. Thanks to all that have commented on here! Is there any way I can disable the auto setting and leave the airbag on Ive never been in an accident before but I just get a bad feeling from having it turned off anyway. My last vehicle was an Infiniti and they took appointments. It only does it when the engine is first started cold and will quiet down as the engine runs.
Key At this point I would try to bridge the damaged wires to avoid any further potential damage. When you put the fuse back in the relay Some wiring to check at the bcm. Use your own discretion 2000xj answered 4 weeks ago I've got a 2003 Grand Cherokee Loredo with a constant airbag light on. Consumer writes in regards to airbag indicator light continues to illuminate after occupant restraint control module recall repairs. Is it supposed to, or is a 2003 Jeep too old to have both side seatbelt sensors like modern vehicles do? Check for 12v and ground at the socket. I went to the dealership to have it checked. I have a customer with this Dodge truck that has a lot of lifter noise at cold start.
You dont need to drop the steering wheel. He says there is no rhyme or reason. If you know where the sensor is, you only have to unclip the old sensor and replace it with a new one. Problem may be as simple as a missing ground at the horns horns connectors disconnected badmissing horns. Thanks apba32 Quote Originally Posted by jeep jeepster My ex weighed 115lbs and the light would go on and off. Quote You could leave the clockspring in. At the time I pulled everything apart and checked every connection and fuse I could find and never found a problem.
Im assuming this just plugs into the top of the charcoal airbag impact sensor one on each front corner. There are wires going to the drivers and from there to the seat belt buckle that activate the fasten seat belt light. Once off the highway to my destination, I turned the Grand Cherokee off. Im really glad thats what I was driving. It was replaced but still did not work. Well this is back in 2009, but ain't nobody done it like this yet.
If you do any repairs or work that involves the airbags or parts nearby disconnect the battery and wait 30 minutes for the airbag system to become safe. Just curious on what the chances are of the airbags going off while off-roading. An ember came out of it and fell on the carpet in the back and burned a hole all the way down to the metal, now my cluster panel is going nuts and all of my electrical is malfunctioning. . No crashes were reported however injuries consisting of cuts and burns were alleged. These issues occur before and after vehicle is started.
So I set a budget of 3k. Does it click when you push the button If relay clicks then wiring horn connectors horns may be bad. Yesterday I was driving along and all of a sudden it started randomly honking without me even touching the horn button s on the steering wheel. Other times its only for Hi guys. When you are not there the comp.
I bought the jeep recently and it was in a small accident with a deer but no airbags went off or anything. I'll keep you posted on the results of that. It's attached by two plastic clips in the back top and bottom. I checked the wires under the seats and they look fine. Good observation and by the way im not firing at you just want to make sure everyone stays safe out there. The airbag light came on. So Im working if my gremlin is coming from something in the seatbelt sensor wiring Any ideas or input hi there yes my tail light wires were causing me problems.