Loosen each wheel lug nut one-half turn counterclockwise but do not remove them. Hydraulic brake booster system Hydroboost The Hydroboost system receives fluid pressure from the power steering pump to provide power assist during braking. After a few minutes, select any desired position. No additional vehicle service is required. Batteries normally produce explosive gases which can cause personal injury.
The wheels are prevented from locking even when the brakes are firmly applied. Use only fluid that meets Ford specifications. This will eliminate excessive downshifting and upshifting for optimum fuel economy and transaxle cooling. Set the parking brake and ensure the gearshift is securely latched in P Park automatic transmissions or 1 First manual transmissions. Avoid getting fuel liquid in your eyes. Check to make sure the encoded ignition key is an approved Ford encoded ignition key.
Remove the jumper cable from the ground metal surface. Do not drive your vehicle until you verify that the brakelamps are working. However, the fluid level should be checked if the transaxle is not working properly, i. Rotate to full up position past detent to turn on interior lamps. This front-engined car dated 6-speed manual transmission and rear-wheel.
Make sure the jack is fastened so it does not rattle when you drive. Refer to Engine coolant in the Maintenance and care chapter. Rinse thoroughly with clean water. If the light fails to illuminate, continues to flash or remains on, have the system serviced immediately. Without turning, remove the old bulb from the lamp assembly by gently pulling it straight out of the lamp assembly. Refill this reservoir with the same fluid you use for your windshield.
Do not pile cargo higher than the seatbacks to avoid injuring people in a collision or sudden stop. The pressure in an overfilled tank may cause leakage and lead to fuel spray and fire. Hard objects can injure you in a collision. Unfortunatley the car did not come with an owners manual explaining some of the options. Remove bulb socket by turning counterclockwise. Department of Transportation requires Ford to give you the following information about tire grades exactly as the government has written it. Cleaning plastic exterior parts Use vinyl cleaner for routine cleaning.
Clean with a tar remover if necessary. This system meets all Canadian Interference-Causing Equipment standard requirements regulating the impulse electrical field strength of radio noise. Avoid touching the glass envelope. It also illuminates when the Traction Control system begins applying and releasing the brakes and adjusting the engine characteristics to limit a wheelspin condition. Close the hood and turn off the lamps. Install the child safety seat in a seating position which is capable of providing a tether anchorage. Never let a passenger hold a child on his or her lap while the vehicle is moving.
Rotate to the second position to also turn on the headlamps. The vehicle may need to be driven 16 km 10 miles or more to relearn the idle and fuel trim strategy. If service is necessary, see your dealer or a qualified technician. Standard instrument cluster Optional instrument cluster Driving with your tachometer pointer in the red zone may damage the engine. Insert the belt tongue into the proper buckle the buckle closest to the direction. Anyways, supposively it came with its own carrying cart, and required two people to put them on and off.
Safety belt warning chime Chimes to remind you to fasten your safety belts. Ford design rear axles contain a synthetic lubricant that does not require changing unless the axle has been submerged in water. Engine torque reduction is realized via the fully electronic spark and fuel injection systems. Front and rear seat occupants, including pregnant women, should wear safety belts for optimum protection in an accident. The parking brake is not recommended to stop a moving vehicle. Servicing after towing If you tow a trailer for long distances, your vehicle will require more frequent service intervals. Combination lap and shoulder belts Before fastening the safety belt, make sure the shoulder belt passes through the belt holder on the top of the seatback.