No need to aim if you just change the bulbs. Next hold the new bulb by the metal base caution: do not touch or scratch the glass in the right orientation to fit the 3 small prongs into the 3 notches. You need to take off the black plastic shroud around the headlight. Replace wire clamp and fasten top first, then re-hook bottom. Only remove the pins that have a screw fitting for a philips head screw.
Aiming is not neces … sary after replacing the bulb. Reverse order when done replacing … light bulb H4. Replace battery or fuse panel. It didn't easily slide out from under the metal lip for me, either, but I finally got it to do so. Once the boot and 3 prong receptacle plug is off the 3 prongs on the bulb are exposed.
Then turn the bulb socket counterclockwise to remove it. The Modified Life staff has taken all its Toyota Camry headlight bulb replacement guide, Toyota Camry light bulb size guides, Toyota Camry light bulb replacement guides and cataloged them online for use by our visitors for free. Feel free to use any replacement ligh t bulb sizes that are listed on Modified Life but keep in mind that all information here is provided as is without any warranty of any kind. Bulb is an H4 and you gain access as stated above. Look at the replacement bulb to see where the tab is. Notice the bulb metal base has 3 small prongs that fit into 3 notches on the base of the headlight housing. When you first turn on the light be sure you are not looking over it in case it does shatter.
After you have unseated the screw, pull out the base of the pin. When aiming adjustment is necessary,contact your Toyata dealer I have a 93 camry. Install the new bulb and install the connector. Look at the rubber boot that is behind the light. Plug in the connector plug with wires. If you do loosen anything,now you have a aiming problem.
Remove the black rubber waterproof boot. To install a bulb, align the tabs of the bulb socket with the cutouts of the mounting hole. I actually removed my battery on my Camry. Push headlight retaining housing retaining clips rectangular metal tabs located above radiator wall and to outside and rear or headlight rearward, then upward to release headlight assembly. Unlatch both rods out of their retainers and pull them straight up and the assy should come out. Detach wire harness by pushing on clips and pull straight out.
Each assembly driver and passenger side also contains a back-up light. Just do the reverse to put it back in. Pinch and pull on the male light plug, then twist off counterclockwise the light bulb socket. I read that oils from your fingers can damage the actual bulb. Here is how you do this: 1.
Turn the bulb and remove it. This is common replacement method for most 90's model Voyagers. I bought it from my local California Toyota dealer. At that point, you can jiggle it around and the bulb just pops out. On the drivers side you need to remove a piece of the air vent tube that is about 5 inches long, but it just pops off. Remove bulb from headlight housing. These kits at one time cost hundreds of dollars but their prices have come down substantially.
It helps to have a little pocket mirror and a small flashlight to inspect how the wireclamp is hooked in, it will make unhooking it easier. Lift away the corner of the trunk floor covering and pull the plastic panel out to expose the corner light bulb connectors. Remove the old bulb and insert replacement. Now, if you want to replace the bulb or complete set, then you have plenty of room to unscrew and replace the whole kit or just replace the bulb. With the bulb and connection made replace the assembly back in the location behind the head light assembly.