The front seat belt system can also be made to lock manually by quickly pulling on the shoulder belt. . Remove the steering column bearing from the steering column lock cylinder housing. If this condition persists, damage to the transmission could occur. Key returns to 4 On when released. The warning lights can be operated when the ignition is off.
For the owner with basic mechanical skills and for independant auto service professionals, this manual includes the same specifications and procedures available to an authorised dealer service department. Using the heater for longer than three hours will not harm the engine, so the heater can be plugged in the night before starting the vehicle. Apply brake and shift into N Neutral. If the engine does not start within five seconds, wait ten seconds and try again. Take your vehicle to a service facility as soon as possible to minimize engine damage. Avoid sharp turns or abrupt maneuvers in these vehicles. Do not bleach or dye the belts, because these actions may weaken the belt webbing.
Rear seat belts if equipped cannot be made to lock up by pulling quickly on the belt. Do not reduce the tire pressures but shift to a lower gear and drive steadily through the terrain. Use 1 First gear and set the parking brake fully. Ford Premium Engine Coolant is an optimized formula that will protect all metals and rubber elastomers used in Ford cooling systems for 4 years or 80,000 km 50,000 miles. Pull the straps to lower the seat cushions.
Temperature Turn temperature control to the desired temperature. If fuel is swallowed, call a physician immediately, even if no symptoms are immediately. Carefully pull the dome lamp lens from the lamp assembly. The flashing headlamps and the honking horn automatically shut off after about three minutes and will remain off unless another unauthorized entry is attempted. Each time you fill the tank, record the amount of fuel added in liters or gallons.
Remove the transmission selector lever arm and support 7302. Pull headlamp control towards you to turn foglamps on. Push the lever back up to lock the steering wheel into position. However, the vehicle will not start until the system is disarmed. Use only fluid that meets Ford specifications. Manufacturer identification is located at the end of the webbing on the label. Improperly inflated tires can affect vehicle handling and can fail suddenly, possibly resulting in loss of vehicle control.
Remove particles such as bird droppings, tree sap, insect remains, tar spots, road salt and industrial fallout immediately. If your vehicle is particularly dirty, use a quality car wash detergent. On tilt steering columns, remove the sensor ring. Grasp the shoulder belt portion and pull downward until the entire belt is extracted. The driver-side power window has a one-touch down feature. Do not make any unauthorized changes to the vehicle or engine.
Refer to Air suspension load leveling in the Driving chapter for more information. The flashing headlamps and the honking horn automatically shut off after about three minutes and will remain off unless another unauthorized entry is attempted. Carefully snap the dome lamp lens into the dome lamp assembly. The pressure in an overfilled tank may cause leakage and lead to fuel spray and fire. Remove the steering wheel bolt. Carefully remove the jack handle from the retaining clips above radiator in engine compartment.
Clean the reservoir cap before removal to prevent dirt and water from entering the reservoir. Never adjust the steering wheel when the vehicle is moving. Install the steering column lock gear. Add only enough fluid through the filler opening so that the fluid level is at the bottom of the opening. Adherence to the toe and ride height specification is important for proper tire wear, ride, handling and headlight aim.
To prevent the risk of injury, make sure children sit where they can be properly restrained. Allow more stopping distance and drive slower than usual. Windshield washer fluid reservoir 4. This process will also arm your anti-theft system. While applying downward pressure on the hood, push the hood latch handle located just left of the center of the hood. Install the steering column bearing sleeve.